6459 State Highway 23
Oneonta, NY 13820
607-432-6641 • Fax 607-433-6284
65 State Route 369
Port Crane, NY 13833
607-648-7051 • Fax 607-648-7050
Oneonta Block Company


CEMENT / FOUNDATION COATING

Masonry/Mortar/Portland - Premix - Concrete Repair/Patch/Grout - Sand - Miscellaenous - Spec Mix




Heavy Duty Masonry Coating

#40FCG & 50FCW


40 Lb. Bag Quikrete Heavy Duty Masonry Coating - Portland, Additives

A powdered, Portland Cement based coating designed for use in damp proofing and beautifying concrete and masonry walls. It adheres to the surface in a manner that allows it to become part of the masonry it covers. For use inside or outside, above and below grade. Will withstand extreme heat, moisture and cold and is suitable for any climate. It is recommended for damp proofing brick, block, stone and poured-in-place concrete walls. Available in Gray or White

Particularly suitable for use on non-uniform colored masonry walls and improperly cured and map cracked concrete walls. It stops moisture, holds back water, seals and beautifies:

  • Porous masonry concrete
  • Rough cement plasters
  • Stucco
  • Stone
  • Brick
  • Concrete block



Surface Bonding Cement

SKU #50SBG

3500 PSI



50 Lb. Surface Bonding Cement - Portland, Lime, Sand, Fibers, Additives

A quality mixture of cement, lime, sand, fibers and special additives. Used to build, decorate and damp proof dry stack concrete block walls. Can also be used to strengthen existing mortared or dry stacked block walls. Structural applications where safety is a concern should be designed and approved by a licensed engineer. Can be used for both interior & exterior uses. Available in gray or white. Covers appx. 50 sq. ft. at 1/8" thick.

Use for:

  • Dry Block Construction
  • Waterproofing Block Walls